PDA

View Full Version : Toyota 4 runner tortion bars


deer laredo
03-10-2013, 02:26 PM
Wondering the maximum i should crank my tortion bars to lift my runner think i could get 3 inches of lift out of them? Without the camber going south?

4skin
03-10-2013, 07:24 PM
No maybe 1.5 to 2 inch and it will ride like a shopping cart
Plus you will have little to no droop out of it
I had 33 10.5 on my 86 with no lift and slight trimming
And it wheeled fairly well
But on road drivability suffered with stock gears

youngun
03-10-2013, 07:28 PM
how big of tires you want to run?

You can crank em up a couple inches and thats about it like above

deer laredo
03-10-2013, 11:58 PM
Im runnen 33s. Did the first gens or have different gears?? I do need lower gears i have a set out of a first gen mabe toyota had a t case aswell thr had a different ratio??? Im new to the toyotas i switched from jeep. Help me out fill me in with all the tricks i can do for cheap and things ican do with othe toy parts

4skin
03-11-2013, 12:15 AM
Depends on what yours had stock tire size if it had 31 it should be 4.88
Most were 4.10 but there is variations auto standard 4 cyl v6
And a transfer case won't effect road manners hi range is 1.1
I swapped to 5.29 was a bit to much gear for the 33s
But was still way better than the 4.10 but by then truck was straight axle
Dual cased and needed a bigger tire

deer laredo
03-11-2013, 12:34 AM
It had 31s wen i got it its and 89 and its a 22re. 5spd I have a front and rear axle out of a first gen im gona swap into it soon. Im hopen thier a lower gear. It does weel good as os with the 33s an the welded rear but i wanna do a sas swap and biger tires so i need gearing for cheap.

4skin
03-11-2013, 09:30 AM
If you want to do a sas just buy the trail gear ifs elimination kit
Yes it seems exspensive but I was over the cost of it by the time I finished mine
And had used springs and had not replaced everything the kit comes with

deer laredo
03-11-2013, 12:24 PM
Anybody have any ifs parts? I need a front d shaft and a front diff

youngun
03-11-2013, 10:34 PM
I have loads of it but im in kelowna