PDA

View Full Version : Camber adjustment TJ


Lieutenant Johnson
05-05-2011, 12:22 PM
So after doing my swap on the weekend I noticed my camber is off ... kinda looks like this but not as bad / \ .

Any suggestions ? Do I need offset ball joints ?? or just replace with regular ones as my lowers might be shot?

Is the lowers supposed to move or pivot? as the top ones are fixed?

thanks

B
05-05-2011, 12:25 PM
your diff is bent possibly ... [wako]


good thing it's a high pinion lol

Lieutenant Johnson
05-05-2011, 12:43 PM
thats weird as it came out of a Cherokee that was never engaged and you could tell....

god damn... high pinion is good because?

B
05-05-2011, 12:55 PM
the hipin part was sarcasem because hipin is 30 % stonger lol it's still a 30 ...

i hope for your sake it's not todd ... [cheers]

Lieutenant Johnson
05-05-2011, 01:01 PM
no doubt ... you do alignments there bud!

bcmaxx
05-05-2011, 01:26 PM
I got a slightly bent d30 with 4:10 from the wrecker. looked great until I got it in and installed..... Ended up using Napa premium adjustable ball joints upper and lower to correct and optimize caster and camber.

Lieutenant Johnson
05-05-2011, 03:04 PM
Just took another look today at it and it's not even close to as bad as my pointed out. Must have been sitting on angle cuz today looks normal.

England
05-05-2011, 05:02 PM
post pics we have as many OP's here as arse holes

Lieutenant Johnson
05-05-2011, 08:06 PM
post pics we have as many OP's here as arse holes


ask and shall receive ...looks fine today just went to my mechanic who did gears and he said it fine !

vajayjay
05-05-2011, 08:44 PM
HP30 with 4:88s means no worries anymore

I know these things:D

pumpkin
05-06-2011, 08:02 AM
no doubt ... you do alignments there bud!



[15] [15] [15] [15] [15] [15] [15]

D-Ass
05-08-2011, 02:36 PM
its because of the fog lights ! way too much weight on that front end!:confused0006:

Troy
05-08-2011, 03:05 PM
looks fine. did you get your toe in and toe out adjusted? (tie rod)

Lieutenant Johnson
05-08-2011, 04:25 PM
Ended up replacing ball joints on Passenger side and fixed the little lean in. Gonna toe in check this week. Troy pm
Me for directions to hale3

85chevy
05-10-2011, 10:12 AM
Should of replaced them all then u shouldn't have to worry about them for a while

Lieutenant Johnson
05-10-2011, 10:28 AM
gonna do the other side on friday! was already thinking that