PDA

View Full Version : Convert to standard?


godtool
01-16-2011, 04:37 PM
If I put a standard under my tuck is it difficult to re and re the pedals under the dash??

Kingblazer84
01-16-2011, 05:40 PM
shouldnt me too difficult.. but what transmission are you swapping SM465 or nv3500, nv4500 etc.?

godtool
01-17-2011, 06:47 AM
sm465!

Kingblazer84
01-17-2011, 10:00 AM
hyd or manual clutch? your tub on the jimmy should have a pattern on the tranny tunnel already to cut out for the shifter as they were all stamped for auto and standard transmissions and pedals should slide into place of the auto ones

MUD CHILD
01-17-2011, 11:58 AM
The pedals will bolt right in[cheers]

m j
01-17-2011, 06:44 PM
prolley have to drop the steering column and swap out the tunnel thing the pedal assembly is housed in

nothing hard about it, just time and donor vehicle needed for the small parts.
small parts = stuff like the wiring harness for the reverse lights(2 green wires run through firewall to trans), neutral safety switch and wiring that is now part of a VI

arjan
01-28-2011, 10:37 PM
Manual transmissions don't have neutral safety switches. Typically the clutch needs to be pressed to start the engine.

ottoman
02-17-2011, 12:11 AM
Manual transmissions don't have neutral safety switches. Typically the clutch needs to be pressed to start the engine.
which is tipicaly referred to as the neutral saftey switch oh yeah