View Full Version : Extended Driveshafts?

01-01-2011, 10:39 AM
Is there anyone on the site who can lenghten my driveshaft.The lift thats on the Wagoneer has pulled the driveshaft apart 1.5-2 inches and at full flex the shaft will seperate. I need to get this done asap as I'm already driving my jeep to and from work but would really like to get it on the trail soon. Thanks guys [cheers]

dirka dave
01-01-2011, 11:28 AM
Pats drivelines in Port Kells, or Coast Powertrain in BBy.

Used both places.

01-01-2011, 11:37 AM
I've talked to 2 people that had theirs done at pat's and they said the work was crap and expenive. Anyone have a good expeirence with pats driveline?

01-01-2011, 11:58 AM
Had mine done at coast did a good job, and they're all expensive

01-01-2011, 06:45 PM
it might be cheaper for you buy a longer driveshaft from PnP or scrounge one and have them shorten it (if yuo can find one of similar application). lengthening means they have to buy the metal new to redo the tube, but it should only cost $75-100 to shorten one.

just a thought, not sure if it's feasible for you.


01-01-2011, 07:13 PM
or weld a shd 40 pipe up and have them balance it for you?

01-03-2011, 05:09 PM
Coast was very good to me.

Made me a custom d-shaft (actually made me two) that didnt end up working because of a vibration, refunded me all the $$ and didnt charge any labor to fix my old d-shaft.

You get what you pay for..

01-03-2011, 06:00 PM
driveline specialties in surrey on 82nd ,good prices and good work [cheers]

01-04-2011, 11:11 AM
Yeh I've heard good things about Driveline in surrey.looks like I'll be going to them. thanks guys

01-04-2011, 08:42 PM
they did both drive shafts on my chev and both on my old toyota ,never had a problem[cheers]

Evan the Blue
01-04-2011, 09:02 PM
Coast has always done good work for me

Cheese eyes
01-04-2011, 11:16 PM
driveline specialties in surrey on 82nd ,good prices and good work [cheers]

[iagree] good guy and good work !!

01-18-2011, 11:42 PM
I got my bronco shafts done in chilliwack at a machine shop. Both front and rear legthened with new u joints needed was 253 or something, Havent had a problem

Front shaft got new slip joint..

Rear shaft was new tube, I put my 460 in and destroyed every single part in my drive shaft... So its brand new stuff.




01-19-2011, 07:44 AM
woo shiny

01-19-2011, 12:41 PM
If you don't drive everyday on the street just cut the the shaft right in the middle, pull it apart how ever muchy you need to lengthen it and slide a peace of shd 40 over top the length of the entire driveshaft and weld it on the ends. It will be straight enough and strong. I wouldn't do that if it was a daily driver. But for a trailer, weekend wheeler it works good.

01-21-2011, 12:55 AM
Coast is good to deal with and open sat if you can't get there jurying the week.:)