PDA

View Full Version : Need U-bolt plates made for dana 70


78'460
11-27-2010, 12:09 PM
What the title says, Thinking 5/8 " steel. Axles going under bronco, I just need to get axle tube width and leaf pack width, Who do you guys suggest and how much am I looking at for 2?

vajayjay
11-27-2010, 12:14 PM
I suggest you get those measurements, buy steel and drill holes

78'460
11-27-2010, 12:52 PM
I suggest you get those measurements, buy steel and drill holes

I was just going to get them made, With my luck ill fuck em up

epic3
11-27-2010, 12:54 PM
they are real easy to make. 5/8ths is kinda over kill tho IMO

78'460
11-27-2010, 01:00 PM
they are real easy to make. 5/8ths is kinda over kill tho IMO

Can never be over kill [36]

Ok ill go pick up some steel and a good drill bit

mini
11-27-2010, 04:30 PM
ive sugested it to you before and ill say it again

go see rick at chilliwack spring

78'460
11-27-2010, 07:09 PM
ive sugested it to you before and ill say it again

go see rick at chilliwack spring


Rick is putting the d60 front and d 70 rear under the truck, plus holding the axles for me, he will be sending outt driveshafts to pats driveline to get built, He got the lift for my bronco, I did go see him. He suggested a place to get them built on young rd but I forgot and that is in chilliwack I now live in langley.