PDA

View Full Version : 22re timming cover??


4skin
08-18-2010, 08:28 PM
is it possible to pull cover without pulling head found
a broken bolt on heater tube right against block :mad0217: [27] [27]
im sure you can also cheepest place to get gasket set abbotsford area

Spedley
08-18-2010, 08:37 PM
Yes it can be done. Been there, done that. Sometimes you will have to drop the oilpan a bit.

Jayota
08-18-2010, 08:37 PM
Yes.

Its very tight. The gasket usually likes to bind when the cover is going in. IF you can remove the oil pump drive spline from the crank it will give you a little more wiggle room for the cover on the way in.

4skin
08-18-2010, 10:22 PM
thanks guys managed to get busted bolt out[2a]
sure didnt want to pull this apart

LooseNuts
08-18-2010, 10:30 PM
yup i have done it before.

Jayota
08-19-2010, 02:40 AM
thanks guys managed to get busted bolt out[2a]
sure didnt want to pull this apart

gotta love it when the broken bolt actually comes out :D