PDA

View Full Version : 205 gurus


FU Toolbag
03-29-2010, 08:14 PM
Popping appart my dodge 205 tommorow. I need to put the input from it into a ford 205 case. I basicly have some internal concerns. Do I have to swap all the gears or can I just swap inputs? I've stripped out another ford case just to remember how they go together, bin years since I rebuilt a 205. I'm gonna try and just swap the input to start with.



Any thoughts?

4skin
03-29-2010, 10:45 PM
been long timefor me to think there same check two inputs gear diameter etc what are you doing using dodge transfer case in ford to switch drop???

FU Toolbag
03-29-2010, 10:57 PM
no, guts of dodge into ford case to put cummins in a chev.

Cheese eyes
03-29-2010, 11:26 PM
is the dodge 205 a 29 spline? if it is, i think the dodge input bearing is a bigger out side diameter than the ford so you would need to machine the ford case to fit it:dontknow:

was going to do this once befor and cant remember why i didnt :confused0006:

4skin
03-29-2010, 11:33 PM
perfect idea if bearing dieameters are different sometimes you can get
diferrent bearing with iner and outer dieameter you need

patford
03-29-2010, 11:46 PM
Think its just different bearings sizes , should beable to do a mix and match .

m j
03-30-2010, 05:53 AM
can you post pics of the bearing differences
the ford will have the big bearing bore like the 32spline chevy
if the dodge is bigger then that is a third case design
my recollection is that the dodge is just a chevy fig8 style input pattern case, so it would have the small bore case

FU Toolbag
03-30-2010, 08:51 PM
125065

Dodge appart

125066

Ford appart

125067

dodge ouput assembly

125068

Dodge input

125069

and 20 minutes later

125070



125071

And the start of new addapter.

125072

4skin
03-30-2010, 10:24 PM
cool sure it would work bearings the same???

Troy
03-31-2010, 01:07 AM
thats a nice chunk of ??? what is that seamless pipe? dom tubing?

m j
03-31-2010, 06:54 AM
thanks for pics
chevy fig8 case bored to the large bearing size,
a chevy guru would be able to say if that was used behind th400s from the factory before they went to the newer 6 bolt round pattern

so the dodge trans uses a coupler to mate with that shaft?
is it an auto or getrag you are using?
iirc the dodge pattern is a differently clocked version of the ford round 6 pattern so adapter will be easy

FU Toolbag
03-31-2010, 05:38 PM
Using the getrag. Not by choice, more by coin.