PDA

View Full Version : dana 60


Muddy Heep
03-01-2010, 11:27 PM
i'ma looking 4 some dana 60s ford diffs .what is the best year of diff??? r they all 35 spine [36]looking 4 more inflow on the diff.foodfood they r going in my big block yj

4skin
03-01-2010, 11:38 PM
[36] [36] food for a rear you want a sterling out of 90s ford
brake drums come off without pullin axels
axels make a 60s axel look like a ten bolt chevy
some 60 fronts have 44 size axels look at u joint

Happypants
03-01-2010, 11:42 PM
Keep your eyes open on craigslist dood, got a d60 and 14bt for 325 bucks, can't go wrong :D

4skin
03-01-2010, 11:46 PM
yea kness pu 60 and a sterling with cross steer under a g note

xtremeyj
03-01-2010, 11:52 PM
Keep your eyes open on craigslist dood, got a d60 and 14bt for 325 bucks, can't go wrong :D

yours was broken wasnt it? and then you need to do axle shafts and brakes and bearings and.......
yes they are all 35 spline inners but outers are 30 spline, unless you buy the aftermarket 35 spline


just buy mine off me, already built to whatever you can throw at em.

Deathtrap
03-02-2010, 06:55 PM
If you go sterling make sure its from a 93-97 truck, they have a longer pinion, 92-older have a shorter pinion and are more prone to pinion bearing failure. R&P sets are also cheaper on the 93-97.
As for the 60, most people prefer the late 70's kingpin high pinions because the driver's side axle tube is longer than on the 86-91 D60KPHP, and most 92's were balljoints and everything after 93 was balljoints.

theborges
03-02-2010, 08:25 PM
goto pirate 4x4 and read there dana 60 bible. every bit of information you could want about dana 60's

4linkfota
03-16-2010, 08:47 PM
I got a 60 rear from a 80's truck not sure the gears for 50$.

Explorer guy418
03-16-2010, 09:00 PM
full float rear or 14B and king pin 60

Happypants
03-16-2010, 09:30 PM
full float rear or 14B and king pin 60


That's what I'll be running hpd60 front and 14blt in the rear

MikeWild
03-16-2010, 10:11 PM
I've got an 89 F350 king pin Dana 60 with your choice 3:55 or 4:10 gear set, complete with hubs, rotors. 35 spline inners / 30 outers all cleaned up, taken apart and sand blasted. $1100 O.B.O. if yer interested.