View Full Version : d 60 cast peice
01-11-2010, 11:38 AM
going for a longshot here but on the later model 60s the spring perch is cast into the pumpkin and it requires a cast peice on the bottom for the u bolts to sit into i think i lost it in the prosses of pulling it some how does anyone have one of these know where to get one or have a solution to get around this?
01-11-2010, 02:12 PM
Have a buddy that has a set , can ask , but just do a u- bolt flip much nicer
and easy to do .
01-11-2010, 06:55 PM
how do u do it do u cut the pumpkin?
01-11-2010, 07:13 PM
Some people just cut a groove , I drill a hole .
01-11-2010, 07:28 PM
yea i just looked it up on google the hole seems good
where can u get a plate for the offset u bolts and can u get them with the shock mounts on them?
01-11-2010, 09:11 PM
Made mine out rear plate ,ground out the holes and welded the inside up .
Could make a ttb plate work .
01-11-2010, 10:12 PM
i think i might have some ttb plates kickin from a dana 50 should be able to use those
vBulletin® v3.6.4, Copyright ©2000-2018, Jelsoft Enterprises Ltd.