PDA

View Full Version : slave


F150HULK
12-23-2009, 02:04 PM
has anyone ever had any luck bleeding their slave when it seems to be failing? Just wondering if should even bother. Just start pulling tranny?

crazylike
12-23-2009, 03:18 PM
i find if you do slave then you should do the master aswell otherwise it seriously cuts down on the life span of the parts. and as for reviving it by bleeding i doubt it..

B
12-23-2009, 03:42 PM
interal or external rod ?

m j
12-23-2009, 06:33 PM
the only way a slave fails is its a leaker
so it will leak fluid when you depress the pedal and probably grab a gulp of air through the leak when it retracts

Nutbar
12-23-2009, 06:38 PM
They are just as bad for the master cyl too Rod so look up on the inside of the fire wall above the fuse box and see if it has any trickle marks coming from the clutch master pushrod

and you might be able to get some clutch back for a little while by bleeding it, but if it is leaking it is only a matter of time before it lets go completely

Always broke
12-23-2009, 07:06 PM
No problem it will blow up on the spudspudspudspudspud run!!!!!!!HEHEHEHEHEHHEHEHEHEHE

F150HULK
12-24-2009, 10:55 AM
its not got any leaks any where and it is internal. Maybe just give it a shot bleeding. if its not 100% by spudspudspudspudspud it'll be fully replaced. Hope to take it out for a mild beating Jan 1. at the anuall tree burning.

Thanks Guys!!!!!!!!!!!!!! [cheers]

deer laredo
01-04-2010, 01:38 AM
if the slaves not leaken then its prop the master...