PDA

View Full Version : Fuel Cell info


bakelite
11-27-2009, 03:48 PM
I bought an RCI Fuel Cell part no 2150A for my Toyota with 22R engine. The only line marked on the tank is for the rollover valve RCI #7020A.

I've done a lot of searching and sent emails to everyone I can find that sells these with little result. So I have a couple questions.

1. Does the rollover vent also act as a vent in normal operation then if you roll it over it restricts the leakage of fuel? I saw this on one site that normally it acts as a vent. :dontknow:

2. In the picture, considering it's for a 22R, where do fitting A, B and C go? D is for the rollover vent.

118506

Any help is much appreciated, I'm a newbie at this. Thanks, Joe. [cheers]

Spedley
11-27-2009, 04:59 PM
If'n that was mine, I'd run A to the carb, B would be capped off, and C would be the fuel return. I think I'd also put A and B facing to the rear of the vehicle.

epic3
11-27-2009, 06:15 PM
yes A to pump B capped off C return and D vent, has to have a check valve for rollover protection.

B
11-27-2009, 06:16 PM
don't forget step E high range pin it to win it [5][5][5] ...

and [stupid] ...

bakelite
11-28-2009, 05:03 AM
Thank you [cheers] [36] [36] [36]



"step E high range pin it to win it " :D [36]

BajaDale
12-12-2009, 09:42 PM
Just from experience those fuel tanks are prone to crack alot!!! They're meant for pavement use I guess...:dontknow: (won't call it a cell because a cell has a bladder) Just a heads up[cheers]