PDA

View Full Version : stand alone ignition system


FU Toolbag
07-28-2009, 10:59 AM
I need a wirinbg diagram for a stand alone ford ignition system. I basicly need to know what wires to use in the duraspark system so I can bypass the entire stock harness and get this thing running.

MikeWild
07-28-2009, 11:43 AM
maybe this will help

Nutbar
07-28-2009, 12:34 PM
I don't know what you are using for a stand alone but the Duraspark ign is easy . . .

Now I can't remember colour codes but this is the basic idea

Ign module has one 2 pin plug and one 4 pin plug,

. . . 2 pin plug has one ignition power lead(red I think) and one spliced to starter crank lead(white I think)

. . . 4 pin plug has one lead to coil negative(I want to say green), one lead that grounds in the distributor base(I'm pretty sure it's black), and 2 leads that go to distributor magnetic pick up(should be purple and orange) - one high and one low signal referance

Distributor has one plug with 3 leads, these all go back to the ign module . . . ground lead, pick up high, and pick up low

Coil has 2 leads, coil posative to ignition power switch (on the jeeps this power lead is resisted to reduce voltage), coil negative to ign module.

epic3
07-28-2009, 12:53 PM
are you using the wasted spark edis system?

m j
07-28-2009, 09:31 PM
he is asking for duraspark

http://www.lonestar-ebc.com/Tech/TechPictures/4/DurasparkII.gif

Nutbar
07-28-2009, 11:33 PM
Hey I was right on my ign box colour codes[redneck] :party0010:

rmiller026
07-29-2009, 01:31 AM
why not dich that shit and get a hei ignition buddy of mine got one for 60 bucks on ebay one wire to run

m j
07-29-2009, 06:39 AM
HEI is junk, your buddy got ripped off